Lissmac UNICUT 520, Руководство по эксплуатации

Страница: 24 / 92

24/92
4. COMMISSIONING
4.1. Connections and media
Diesel (DSL) Use only diesel fuels according to EN 590 / ASTM D 975 No. 2D with a Sulphur content <15 mg/kg
(so-called ULSD (Ultra Low Sulphur Diesel)). When using other fuels, the emission levels change and the
warranty expires.
Engine oil
Use only engine oil approved by DEUTZ. Use at least quality grade DQC III-10 LA. The use of lower
qualities will halve the maintenance intervals and the warranty may be voided.
Dispose of old engine oil properly with your disposal company in an environmentally conscious manner.
Observe the engine manufacturer's operating instructions, enclosed with each machine.
Pay particular attention to the safety and maintenance instructions.
Antifreeze Use only antifreeze approved by DEUTZ. Use release grade DQC C_-14. The use of lower qualities will
halve the maintenance intervals and the warranty may be voided.
Lubricant
Only use quality grease on the grease nipple. The grease used on the floor saw has the name "Energrease
LS2 BP".
(Lithium-based multi-purpose grease of NLGI grade 2 according to DIN 51818/NLGI GC - LB grade 2)
Hydraulic oil
The hydraulic fluid used must be of HVLP (High Volume Low Pressure) quality (according to DIN 51524-3 /
ISO 6743/4) in the ISO viscosity class 68.
Water The water pressure in the supply line must not exceed 5 bar.
If necessary, use pressure reducer and reduce the water pressure to max. 5 bar.
These specifications refer to the usual operational and ambient conditions.
Other specifications may be required for use under extreme climatic conditions.
4.2. Tools (saw blade)
NOTICE
Tool selection
No rotating tool, whose maximum speed is lower than the rated speed of the machine, must be used.
Defective or broken tools must be replaced immediately.
Selecting a saw blade
See section 12 Tools
Storing tools The tools used must be protected from moisture. The segments installed around the saw blade must be
protected from damage.
S≤15 mg/kg