Odyssey System operations
9
U
se your CAB-1 remote to turn the
Odyssey System speed control on or off.
The marker lights will flash twice after each
sequence has been entered.
The Odyssey
switch position (see page 5) is the
Odyssey system default setting when
you power up the locomotive.
You
may override the default with the following
commands. The override settings will be
cleared and the default settings will be
restored when the locomotive is powered
down.
Odyssey System Command operation
Turns off Odyssey System speed control
Marker lights blink twice
Turns on Odyssey System speed control
Marker lights blink twice
Do not wait longer than two-three seconds between pushing the buttons in each sequence. If
the command is not accepted, repeat the sequence.
The locomotive must be in “neutral” while enabling or disabling the Odyssey
System speed control.
Note!
