18
TrainMaster Command operations
Reprogramming the Command reverse unit to restore features
D
ue to the inevitable derailments and
static, it is possible that the Command
reverse unit in the locomotive or the tender
could someday lose its setup program. The
symptom of this condition would be
unresponsiveness in Command mode. This
can be easily remedied by “reprogramming”
your Command reverse unit using the
following steps.
STEP 1:
Move the switch on your unit from
RUN to PROG.
STEP 2:
Plug in your Command Base.
STEP 3:
Place the unit on track, then turn
on power to your track.
STEP 4:
Press “ENG” then input the unit’s
ID#. Press “SET.”
STEP 5:
Press “ENG,” the ID#, “AUX1,”
then press
6
for your Veranda or tender.
STEP 6:
Turn off power to your track and
wait ten seconds.
STEP 7:
Remove the unit from your track,
and move the switch from PROG to RUN.
STEP 8:
Place the unit back on track, then
turn on power to the track.
STEP 9:
Press “ENG” and the ID#, then
operate as normal.
