Y
our Veranda and tender were factory-programmed as a lash-up. When you press TR, 9 on
the CAB-1 Remote Controller, both units respond together, allowing the headlight and
back-up lights to work together. Remember, you can always address an individual unit in a
lash-up using its ENG ID#.
You will need to build a new lash-up if you want to change the lash-up (TR) ID#, add an
additional locomotive, or assign new individual ID#’s to any part of the consist.
To build a lash-up, assign a unique engine (ENG) ID# to both units. Arrange the units on
the track and couple them together. The Command reverse unit switches must be set to
RUN/FORWARD.
If you press a wrong button, start over with that particular unit; the assignment isn’t
saved until you press SET on the CAB-1.
Start with the Veranda.
1. On your CAB-1 remote controller, press TR, then enter your lash-up ID# (1-9).
No other track or lash-up should be assigned that ID#.
2. Enter the lead unit’s unique ID#, then press F.
3. Press SET beneath the front panel of the CAB-1.
The HORN will blow to indicate that the lead locomotive has been assigned the first
position.
Complete the lash-up by adding the tender.
1. On your CAB-1 remote controller, press TR, then enter your lash-up ID# (1-9).
2. Enter the last unit’s unique ID#, then press R.
It is not necessary to press the DIRECTION button.
3. Press SET beneath the front panel of the CAB-1.
TrainMaster Command operations
17
Building a lash-up
Note!
Note!
Note!