28
Chapter 5: Setting up the Wireless-G Router for Broadband WAN Service Only
Overview
Wireless-G Router for 3G/UMTS Broadband
Chapter 6: Setting up the Wireless-G Router for Broadband
WAN Service Only
Overview
This chapter covers the steps for configuring the Router for broadband WAN service only, such as cable or DSL
service. If you want to configure the Router for 3G/UMTS or GPRS service only, go to “Chapter 5: Setting up the
Wireless-G Router for 3G/UMTS or GPRS Service.” If you want to configure the Router for broadband WAN and
3G/UMTS or GPRS service, go to “Chapter 7: Setting up the Wireless-G Router for Broadband WAN and 3G/UMTS
or GPRS Service.”
Before You Begin
Before you begin, make sure that you have the following:
•
broadband modem
•
settings for your Internet connection type.
The information about your Internet connection type should have been provided when your broadband modem
was installed. If you do not have this information, contact your Internet Service Provider (ISP) for your settings.
Using the Setup Wizard
1. Insert the Setup Wizard CD-ROM into your CD-ROM drive. The Setup Wizard should run automatically, and the
Welcome
screen should appear. If it does not, click the
Start
button and choose
Run
. In the field that
appears, enter
D:\WRT54G3G.exe
(if “D” is the letter of your CD-ROM drive).
2. The Setup Wizard will automatically detect the language setting of your PC. On the initial
Welcome
screen,
click the
Next
button if you want to proceed with the Setup Wizard using the current language. If you want to
use a different language, select the appropriate language, and then click the
Next
button.
IMPORTANT:
If you want to configure the Router for 3G/UMTS or GPRS service in addition to
broadband WAN service, proceed to “Chapter 7: Setting up the Wireless-G Router for Broadband
WAN and 3G/UMTS or GPRS Service.”
Figure 6-1: Setup Wizard’s Welcome - Language
Selection Screen