![background image](http://html1.mh-extra.com/html/linksys/rvl200/rvl200_user-manual_1924696036.webp)
23
Chapter 5: Setting Up and Configuring the Router
Setup Tab - Network
4-Port SSL/IPSec VPN Router
Static IP
1. If you are required to use a permanent IP address, select
Static
IP
.
2. Enter your settings in the
Specify WAN IP Address
,
Subnet Mask
,
Default Gateway Address
, and
DNS Server
fields (at least one DNS Server IP address is required). Check your service installation receipt for this
information; otherwise, request these settings from your ISP.
3. The MTU (Maximum Transmission Unit) setting specifies the largest packet size permitted for network
transmission. To manually set a value, select
Manual
and enter the value desired in the field provided. You
should leave this value in the 1200 to 1500 range, and most DSL users should use the value 1492. The default
is
Auto
, which allows the Router to select the best MTU for your Internet connection.
4. Click the
Save Settings
button to save your changes, or click the
Cancel Changes
button to undo them.
PPPoE (Point-to-Point Protocol over Ethernet)
Some DSL-based ISPs use PPPoE (Point-to-Point Protocol over Ethernet) to establish Internet connections for
end-users. If you use a DSL line, check with your ISP to see if they use PPPoE. If they do, you will have to enable
it. To enable PPPoE, follow these instructions:
1. Select
PPPoE
.
2. Enter your User Name and Password. The maximum number of characters is 60.
3. If you select the
Connect on Demand
option, the connection will be disconnected after a specified period of
inactivity (Max Idle Time). If you have been disconnected due to inactivity, Connect on Demand enables the
Router to automatically re-establish your connection as soon as you attempt to access the Internet again.
Enter the number of minutes you want to have elapsed before your Internet access disconnects. The default
is
5
minutes.
If you select the
Keep Alive
option, the Router will keep the connection alive by sending out a few data
packets periodically, so your ISP thinks that the connection is still active. This option keeps your connection
active indefinitely, even when it sits idle. The default Redial Period is
30
seconds.
4. The MTU (Maximum Transmission Unit) setting specifies the largest packet size permitted for network
transmission. To manually set a value, select
Manual
and enter the value desired in the field provided. You
should leave this value in the 1200 to 1500 range, and most PPPoE users should use the value 1492. The
default is
Auto
, which allows the Router to select the best MTU for your Internet connection.
5. Click the
Save Settings
button to save your changes, or click the
Cancel Changes
button to undo them.
Figure 5-16: Static IP
Figure 5-17: PPPoE
Содержание RVL200
Страница 170: ...157 Appendix Q Regulatory Information 4 Port SSL IPSec VPN Router ...
Страница 171: ...158 Appendix Q Regulatory Information 4 Port SSL IPSec VPN Router ...
Страница 172: ...159 Appendix Q Regulatory Information 4 Port SSL IPSec VPN Router ...
Страница 173: ...160 Appendix Q Regulatory Information 4 Port SSL IPSec VPN Router For more information visit www linksys com ...