Linkam Scientific Instruments FDCS196, Руководство пользователя

Страница: 14 / 40

14
FDCS196 Pro System Setup
Only read the following section if you have pur-
chased the FDCS196 Pro System.
Edwards Vacuum Pump Setup
Please read the Edwards Vacuum manual to fill
the pump with oil and to install the mist filter (1).
MV196 Motorised Valve System Set-
up
The MV196 Motorized Vacuum Control System
consists of a motorized valve (2) connected to a T
-
piece (3) on top of the Edward Vacuum Pump
(4).
Please note that the motorized valve accurately
controls the vacuum within the stage but the max-
imum vacuum possible is not as great as when
using a simple on/off style valve.
Mounting the MV196
The MV196 has an vacuum flange just like the
vacuum ports on the sides of the FDCS196 Stage.
Use a small amount of vacuum grease to coat a
thin layer on the surface where the O
-
ring will sit.
Coat the surfaces of the T
-
piece with vacuum
grease as well. The valve has two ports, there is
one in line and one protruding perpendicularly out
of the side of this valve. The side port (5) is for
the controlled vacuum vent and therefore should
not have anything attached to it.
Use the Clamping Bracket (6) to secure the T
-
piece to the port as seen in the opposite picture.
Secure the vacuum pipe between the stage and T
-
piece using the supplied O
-
rings and clamping
rings (6).
Connect the cable from the MV196 Motorised
Valve to Slot 1; labelled ‘MOT VAC’ (7).
7
2
3
FDCS196
4
1
6
5