Linde 336 Series, Обучение по обслуживанию, Страница: 13 / 168

Service Training
Page 5
Section 2.1
2.1.3 CHECKING AND RENEWING THE TRACTION MOTOR BRUSHES
The motor brushes can be checked for wear and free movement after opening the driver’s overhead guard.
- Block up the truck at the axle.
- Raise the fork carriage and secure against inadvertent lowering.
- Chock the wheels
- Turn off the key switch.
- Disconnect the battery plug.
- Open the overhead guard as far as the second detent position.
- Lift up the rubber covers (4) over the traction motors.
- Remove the brush cover on the traction motors (1) and (5).
- Lift up the pressure springs (2).
NOTE: When lifting the springs from the motor brushes and putting them on the holder, be sure that
they do not slide off and open, as compressing them when the motors are installed is extremely
difficult
- Pull the motor brushes (3) out of the guide.
- Check the length of the motor brushes (minimum length 16 mm).
- Renew worn motor brushes only as a set.
- After renewing the brushes, check the brushes for free movement in the guides and the brush leads for
security.