Lincoln Impinger Aperion 2424E, Руководство по обслуживанию

Страница: 40 / 48

40 Document #: LIN_EO_SM_IMPAPERION2424_4607818 – 07/21
Removal, Installation & Adjustments Section 7
COOLING FAN – REPLACEMENT
1. Shut off power at main breaker.
2. Unplug power cord from power supply.
3. Remove conveyor assembly, if needed.
4. Remove appropriate control box cover
5. Mark all wire leads for reassembly and disconnect wire
leads to the cooling fan.
6. Note: direction of old fan before removing.
7. Remove four screws that hold cooling fan in place.
Remove cooling fan.
8. Reassemble in reverse order.
9. Check oven for proper operation.
HEATING ELEMENT – REPLACEMENT
1. Shut off power at main breaker.
2. Unplug power cord from power supply.
3. Remove sixteen screws at rear panel and remove rear
panel.
4. Remove twenty-seven screws to heating element
assembly. Remove element assembly.
5. Mark all wire leads for reassembly and disconnect wire
leads.
6. Remove six screws that hold heating element in place.
Remove heating element.
7. Reassemble in reverse order.
8. Check oven for proper operation.
FAN MOTOR – REPLACEMENT
1. Shut off power at main breaker.
2. Unplug power cord from power supply.
3. Remove appropriate control tower cover.
4. Mark all wire leads for reassembly and disconnect wire
leads.
5. Remove four screws that hold fan motor in place.
Remove fan motor.
6. Reassemble in reverse order. (For fan in left control
tower, be sure that the open end of fan motor assembly
is facing upward upon installation. For fan in right
control tower, open end of fan motor assembly will face
downward.)
7. Check oven for proper operation.
CONTACTOR – REPLACEMENT
1. Shut off power at main breaker.
2. Unplug power cord from power supply.
3. Remove right control tower cover.
4. Remove six screws that hold service panel in place.
5. Mark all wire leads for reassembly and disconnect wire
leads.
6. Remove four screws that hold contactor in place.
Remove contactor.
7. Reassemble in reverse order.
8. Check oven for proper operation.
CIRCUIT BREAKER – REPLACEMENT
1. Shut off power at main breaker.
2. Unplug power cord from power supply.
3. Remove right control tower cover.
4. Remove six screws that hold service panel in place.
5. Mark all wire leads for reassembly and disconnect wire
leads.
6. Remove six screws that hold circuit breaker in place.
Remove circuit breaker.
7. Reassemble in reverse order.
8. Check oven for proper operation.
CONVEYOR MOTOR – REPLACEMENT
1. Shut off power at main breaker.
2. Unplug power cord from power supply.
3. Remove conveyor assembly.
4. Remove right control tower cover.
5. Remove coupling from motor.
6. Mark all wire leads for reassembly and disconnect wire
leads.
7. Remove four screws that hold conveyor motor in place.
Remove conveyor motor.
8. Reassemble in reverse order.
9. Install coupling on to new motor.
10. Check oven for proper operation.