- - 24
MAINTENANCE INSTRUCTIONS
WALKING BELT CENTERING AND TENSION ADJUSTMENT
The walking belt may occasionally need to be centered and tightened.
TO ADJUST WALING BELT TENSION:
● Run treadmill at approximately 3.5 mph.
● Using Allen wrench, turn both the right and left
adjustment bolts ONE full turn clockwise.
● If slipping continues during use, repeat above steps.
NOTE: It is recommended that the allen wrench clip
be attached to a convenient spot on the treadmill.
And the allen wrench kept in the clip.
DO NOT OVERTIGHTEN the walking belt.
This may
cause reduced motor performance and excessive roller
wear.
NOTE:
When properly tightened, the sides of belt can
be raised approximate 2-3 inches off the board.
TO CENTER WALKING BELT:
● Place treadmill on a level surface.
● Run treadmill at approximately 3.5 mph.
● If the belt has drifted to the right, turn the right adjusting bolt 1/2 turn clockwise and the left adjusting bolt 1/2
turn counterclockwise.
● If the belt has drifted to the left, turn the left adjusting bolt 1/2 turn clockwise and the right adjusting bolt 1/2 turn
clockwise and the right adjusting bolt 1/2 turn counterclockwise.
Picture A
if the belt has drifted to the LEFT.
Picture B if the belt has drifted to the RIGHT.
Содержание D 11.0 Performance
Страница 1: ... 1 OWNER S MANUAL ...
Страница 26: ... 26 EXPLODED DRAWING ...