LightSand S-2500B, Инструкция по установке и эксплуатации

Страница: 42 / 86

4-4 S-2500B Gateway
Replacing the Power Supplies
1.
Open the system doors.
2.
Identify the failed supply using the red fault indicator on the top of the supply.
3.
While grasping the power supply handle, slide the power supply 0.75 inch (2 cm) away
from the PDB, and then lift the power supply out of the chassis (see
Figure 4-4 ).
Figure 4-4: Replacing a Power Supply
4.
To install the replacement power supply, align the stud on the side of the power supply (see
Figure 4-4 ) with the corresponding notch in the chassis, and then lower the power supply
into the chassis.
5.
Slide the power supply toward the PDB until the power supply connector is fully seated in
the PDB connector.
CAUTION: The power supplies are hot-pluggable. Remove and replace only one
power supply at a time.
DANGER: The connectors on the PDB contain high voltages. Do not remove the
metal cover from the PDB or touch the connectors or the power supply.
1 Power supply 1
2 Power distribution board
(PDB)
3 Power supply 2
4 Alignment stud