LightSand S-2500B, Инструкция по установке и эксплуатации

Страница: 33 / 86

System Configuration 3-5
Establishing a Point to Point Connection
A logical channel runs from a termination point (TP) on one gateway to a TP on another
gateway in the network. The only type of TP currently supported is Packet Over SONET
(POS). The
S-2500B Gateway supports only one POS TP on the SONET port.
Create a channel (a point to point connection) between the new node and another gateway
using the example below as a guide. For more information refer to
Configure a Termination
Point (page A-15) in the CLI appendix.
To establish a point to point connection:
1.
Create a physical link by attaching a cable between the WAN 1 ports on the two gateways.
2.
Configure the WAN 1 port on each gateway to be a SONET port.
3.
On each gateway configure a POS TP on the SONET port:
gateway:> config tp
pos 1
4.
View the commands available for configuring the TP:
gateway/config/tp/pos/1# ?
Sub-Context: ip
Cur-Context:
create <time-slot> <payload-type>
delete
name <tp-name>
description <tp-descr>
admin-status <admin-status>
credit-grant-threshold <credit-grant-threshold>
credit-grant-period <credit-grant-period>
init-round-trip-delay
5.
C reate the TP, for example with ch-c timeslot and FC payload:
gateway/config/tp/pos/1#
create ch-c fc
(
The CLI then prompts for entry of additional parameters.)
6.
Configure an FC port:
gateway:>
config port efc 1 type fc