This product is designed to be mounted horizontally using both the front and rear supports provided. Failure to fit both
front and rear supports will reduce product life and void the warranty.
1.
Remove the front panel screws, as shown in Fig. 3 on page lll, open the unit, detach the earth cable and
remove the dimmer chassis from the lid section.
2.
Fit both the front supports using the 8mm. M4 screws provided to the lid section of the unit.
3.
Measure the distance between the front face of the front rack support and the rear face of the rear rack
cabinet rail.
4. Offer the rear rack support brackets up to the lid section. Move the rear supports until the distance between
the front and rear support is similar to the distance previously measured in the rack cabinet. Mark two holes in
the rear support bracket that best align with the slots in the lid.
5.
Insert M6 cage nuts supplied into the marked holes.
6.
Line up and fix the rear support brackets into the rear of the rack.
7.
Fix the lid section into position in the 19" rack cabinet using the front supports.
8.
Secure the lid section from the inside to each of the rear support brackets using the M6 10mm.bolts supplied.
9.
Slide the chassis partially back into the lid section.
10.
Proceed to page lll.
This product is designed to be mounted vertically in an upright attitude. Failure to mount correctly will prevent the
ventilation system from functioning correctly and may lead to operational problems and will void the warranty.
1.
Open the unit by removing the six screws securing the two front cover plates. Release the earth strap from
each cover plate, noting the order of lockwashers, connector and nut etc.
2.
Three fixing points are provided, as shown in fig. 2 below. Drill the wall and fit suitable screw anchors at
these points and insert 1½" No. 10
(40 x 4mm.) roundhead woodscrews into the two upper screw anchors,
leaving a 3mm. gap between the heads of the screws and the wall.
3.
Hang the Paradime on the two screws, ensuring that the slots have engaged behind both screw heads.
Tighten down the screws, so that the Paradime cannot be moved and insert the third screw.
4.
Proceed to page lll.
LightProcessor Paradime, all variants, version 21, September 2003
Page ll
MOUNTING INTO A STANDARD 19 INCH RACK CABINET
MOUNTING WALLMOUNT MODELS TO THE WALL
Mounting Points
Opening Screws
Opening Screws
Fig. 1
28mm.
80mm.
298mm.
20mm.
148mm.
440mm.
All dimensions relative
to top left corner of Paradim
e
Fig. 2
