Read the instructions in this handbook carefully, as they give important information regarding safety during installation
and use. Be sure to keep this manual with the product for ease of future reference. If the product is sold or given to
another operator, make certain that they also receive the manual.
•After removing the packaging, check that the product is not damaged in any way. If in doubt, do not use it.
Contact an authorised LightProcessor distributor.
•Packaging material (plastic bags, etc.) must not be left within the reach of children, as it can be dangerous.
•The product must only be operated by adults. Do not allow children to tamper or play with it.
•This product must be installed by a qualified electrician.
NEVER USE THE PRODUCT UNDER THE FOLLOWING CONDITIONS:-
•In places subject to excessive humidity
•In places subject to vibrations or bumps
•In places with an ambient temperature in excess of 30°C or less than 0°C
•Protect the product from excessive dryness or humidity (ideal conditions are between 35% and 80%)
•Do not dismantle or modify the product
•Ensure that no liquids or metal objects enter the product
•Should any liquid be spilled on the product, disconnect the power supply immediately
•In the event of serious operating problems stop using the product immediately and either contact the nearest
LightProcessor distributor for assistance or contact the manufacturer directly.
•Never try to repair the product yourself. Repairs or modification could cause damage or faulty
operation. Contact your nearest LightProcessor dealer.
•When carrying out any work, always comply (particularly regarding safety) with all regulations in force in the
country in which the product is being used.
1. Unpack the Product. (Ensure you do not throw away any accessories packed separately in the box.)
2.
Rack models:-
Remove the front panel screws, Fig. 3, page lll. Slide the chassis forward, taking care to release the earth strap
on the right hand side and pull it out completely from the lid section.
Wall models:-
Remove the front panel screws. Remove both panels, taking care to release the earth straps, Fig. 1, page ll.
3.
Rack models:-
Mount the lid section into the rack using both front and rear rack support brackets. Ensure adequate ventilation.
Wall models:-
Secure the chassis to the wall. Ensure adequate ventilation.
4.
If you intend to connect the unit to a single phase supply, fit the single phase input links provided, (10A per
channel units only) Fig. 6, page lV.
5.
Check that the mains input voltage selector links are correctly set for the supply to be connected (115/230V).
Refer to page lll, figs. 4 and 5.
6.
Connect the power input and output load cables.
7.
Rack models:-
Slide the dimmer chassis into the lid section now fitted into the rack. Ensure that the earth strap is
reconnected. Replace the front panel screws. Connect the signal input cables, figs. 10-12, page 2.
Wall models:-
Connect the signal cables.
Replace the front panels and screws, ensuring that the earth straps are re-connected.
8.
Apply power.
9.
Set the required input option (DMX+ANALOG is the factory setting).
10.
Please take the time to read the full instruction manual which contains information on:-
a) The safe use of the product
b) Setting up the special features
c) Adding accessories
d) Routine maintenance
LightProcessor Paradime, all variants, version 21, September 2003
Page l
GENERAL INSTRUCTIONS
QUICK SET-UP AND INSTALL
