Lighthouse solair 3100, Руководство по эксплуатации

Страница: 16 / 188

Lighthouse S3100/S5100/Boulder Counter Operating Manual
1-2 248083389-1 Rev
If replacement of the power supply AC power cord is
required, replace it only with a cord having as good as or
better rating than the cord provided by Lighthouse
Worldwide Solutions. Attempting to use an under-rated
cord can expose the instrument power supply, adjacent
equipment or the user to dangerous shock and fire hazards.
Failure to heed this warning can result in personal injury or
death.
For further technical assistance, contact Lighthouse at 1-800-945-5905
(USA Toll Free) or 1-541-770-5905 (Outside of USA).
The international Caution symbol is located on the rear of the
instrument next to the RS-485 IN port. The symbol will be
accompanied in this manual with a warning about +24VDC being
present on the connector pin-7 when instrument power is applied.
WARNING:
+24VDC is
present on RS-232/485 IN
port pin 7 when
instrument power is
applied.
Port-Connect
Warning
WARNING: Connect to the SOLAIR 1 CFM instrument using
the Ethernet port (top RJ45), RS485 port (2nd RJ45) or USB
port. The instrument will determine which port should be
active and configure it accordingly. Only one interface can
be active at a time. Do NOT attempt to use two or more of
these connectors at one time.
It is suggested that power to the instrument be removed
before changing from one port to another then power the
instrument ON. This warning does NOT apply to the USB
Flash Drive.
Electrostatic
Safety
Information
Electrostatic discharge (ESD) can damage or destroy electronic
components. Therefore, any service or maintenance work should be
done at a static-safe work station. A static-safe work station requires an
ESD consultant to evaluate the work environment and propose the
equipment and apparel needed for just such a work station to be
successful.