LiftEquip TW160, Руководство по эксплуатации

Страница: 60 / 112

Operating manual Installation
TW160 drive
TK Aufzugswerke
60
Version 08/2021
6.5 Mounting the rope guard complying with EN81-77
1. Use the enclosed screws to bolt the rope guard onto the rope guard carrier.
2. Set the rope guard by pivoting or remounting in such a way that the clearance
between the rope and hoop guard does not exceed a maximum of 2 mm over
the entire width of the traction sheave.
3. To align the rope guard, push the enclosed shims between the rope guard
carrier and rope guard.
4. The rope guards on the rope run-in and rope departure positions must not be
mounted more than 15° away from the rope run-in and rope departure
positions.
5. If the angle between the rope run-in and rope departure positions is greater
than 90°, mount a third rope guard in such a way that the angle between all
rope guards is not more than 90°.
6. With inclined pulling, adapt the location of the rope guard carrier by remounting
the changed rope pull direction.
Tighten the securing bolts of the rope guard carrier on the gear drive after alignment
with the prescribed tightening torque.
Item Designation Item Designation
1 Rope guard carrier 2 Rope guard, long
3 Rope guard, long 4 Rope guard, small
Fig. 6.5-1
For machines with rope run-in direction from 0 - 90°above horizontal (e.g. machine
arrangement down/up beside), an additional rope guard is required to prevent foreign
bodies penetrating between the rope and grooves.
If the rope run-in zone is protected within the machine base frame, the function
"protection against injury" is not required.
The rope guards on the rope pulley are to be mounted according to the same
specifications.
max. 2 mm