www.LifeIonizers.com/Support
21
75
9000/9100/9200
1. Softly touch the "Waking/Stand By" button on the front of the ionizer.
→
When you first turn the power ON, there will be up to 5 liters of water
washed through the unit automatically. A green color screen will
blink during this time.
→
After the wash is completed, you may select the operating sensor
for the function you wish.
2. When you select the “Alkali” sensor, you will see each level of pH shown
by colors on LCD screen. There will be a voice message announcing the
level of alkaline water as it is being dispensed.
→
Every touch will raise the level of alkaline water. Keep touching the
sensor until you get the level desired.
→
As it has memory of previously used pH level, it will dispense the
same level of alkaline water as the last setting used.
→
However, if you previously selected and used level 4, it will revert to
level 2 for safety precautions.
3. When you select the “Acidic” sensor, you will see each level of pH
shown by colors on LCD screen. There will be a voice message
announcing the level of acidic water as it is being dispensed.
→
Every touch will raise the level of acidic water. Keep touching the
sensor until you get the level desired.
→
If you last dispensed acidic water, the unit would automatically reset
itself for alkaline water production for a safety reasons.
→
The screen will blink when acidic water is dispensing.
4. When you select the “Purify” sensor, purified water will be dispensed.
The screen will display a green color.
5. When you select the “Washing” sensor, a red color shall display on the
LCD screen. After it automatically washes for 30 seconds, it will return
to Standby mode.
→
If you touch the “Washing" sensor, the screen will blink red and
there will be a voice message saying “Don’t drink the water!”
→
You can do “compulsory washing” function when you need to clean
the electrolytic cell.
→
After the washing cycle is completed, the unit will convert to
alkaline water.
Operation Method
