www.LifeIonizers.com/Support
16
1. Cut the tubing leading to the ionizer at the desired location and length.
2. The cap on top of the filter housing is marked “OUT” and “IN”.
3. The tubing coming from the cold water connector needs to be inserted into the
side of the housing marked “IN”. Firmly press the tubing into the filter-housing cap.
You will feel the tubing stop when it is fully inserted. Pull on the tubing gently to
ensure that it does not come out and a good connection was made. If possible,
flush the filter by turning on the flow of water slowly and point the “OUT” towards
the sink; let it run for 2-3 minutes and turn the water flow off.
4. Insert the tube going to the ionizer into the side of the housing marked “OUT” by
firmly pressing the tube into the filter housing cap.
5. To remove the tubing from the filter cap, press in on the O-ring and tubing simul-
taneously, then gently pull out on the tubing.
TOP VIEW OF FILTER HOUSING
SIDE VIEW OF FILTER HOUSING
Installation of the Pre-Filter
75
9000
75
9000/9100/9200
