www.LifeIonizers.com/Support
42
Q: Why do I want to adjust the amperage on my
Water Ionizer?
A:
As you know, all water sources are not created equal.
Your
water source plays an important role on how your water Ionizer
creates Ionized Alkaline Water. Being able to adjust the amperage
will allow you to find the optimum pH for the best production of
Alkaline Ionized water based on your water source.
Q: How do I adjust the amperage on my water
Ionizer?
A:
Turn machine on. Hold down the "Mode" button for 5
seconds. Scoll through menu by pressing "Mode" until the
Alkali symbol appears and flashes. Press the "Alkali" symbol to
select which Alkali level you wish to adjust. Once you have
selected the Alkali level, press the "" symbol to increase
amperage or the "Washing- " symbol to decrease amperage.
(Note- the unit comes factory set at 50 and can be increased
to a maximum value of 100 or decreased to a minimum value
of 0 in 1 point increments). Once you have completed adjusting
your amperage, press set up to save your settings.
Q: Do I need to hire a plumber to install the units?
A:
Most people find it is not necessary to call a plumber for
most standard installations. For custom installations, a plumber
may be needed depending on the individual circumstances.
Q: What do I do if the filters are leaking?
A:
It is important to note where on the filter it is leaking. Most
leaking comes from fittings that are not seated properly. Reseat
the tubing into the filter by pushing in firmly and then pulling
back. It may be necessary to re-trim the end of the tubing to get
a fresh surface. Make sure to shut off the water before working
with the water supply lines.
75
9000/9100/9200
