LGMG SR3369E, Руководство по эксплуатации и безопасности

Страница: 12 / 64

LGMG North America Inc. Operation and Safety Manual
6
distance among operators, machines and
stationary objects.
1.10 Hazards of Operating on
Slopes
Don't drive the machine on slopes that exceed
the ratings of machine slopes and side slopes.
Slope ratings are applicable to machines in a
rising state.
Model SR3369E
Maximum allowable
angle of operation
(front and rear)
3°
Maximum allowable
angle of operation
(left and right)
2°
Model SR4069E
Maximum allowable
angle of operation
(front and rear)
3°
Maximum allowable
angle of operation
(left and right)
2°
1.11 Falling Hazards
1) During operation, the operator on the
platform must wear a full body safety
device and be secured on approved rope
anchorage points with safety strap hooks.
Each rope anchorage point can only be tied
with one hook.
2) Don't climb or stand on the platform guard
railing. Stand firmly on the platform floor at
all times.
3) Don't climb down from the platform when
the platform is lifted.
4) Keep the platform floor free from debris.
5) Please close the entrance door before
operation.
6) Don't operate the machine if guard railings
are not installed properly or safe operation
cannot be guaranteed at the entrance door.
7) Don't move in and out of the platform
unless the machine is in a stowed state.
1.12 Collision Hazards
1) Pay attention to range of visibility and blind
spots when starting or manipulating the
machine.
2) Pay attention to the position of the
extension platform when moving the
machine.
3) Check the operation areas to avoid
obstacles overhead or other possible
hazards.
4) Be careful of extrusion hazards when
grasping the platform guard railing.
5) Users must comply with service regulations
of personal protection equipment as
required by the employer, in workplace and
stipulated
in government laws and
regulations.
6) Observe and use the direction arrows of
driving and steering functions on the PCU
and platform labels when driving and
steering.
7) Don't operate the machine in the path of an
overhead crane or high-altitude machinery
unless the crane controller has been locked
and/or precautions have been taken to
prevent any potential collision.
8) Prohibit dangerous driving or play when the
machine is operated.
9) It is allowed to lower the platform when
there are no staff and obstacles in the area
under the platform.
10) Restrict driving speed according to ground
condition, jamming degree, gradient, staff
position and any other factors that may
cause collision.
11) Recommend the operator to wear qualified