LGMG S0507SDTCE10, Руководство по эксплуатации и обслуживанию

Страница: 9 / 79

Operation and Maintenance Manual of Aerial Work Platform
Maximum allowable working angle (forward tilting (°))
3
°
Maximum allowable working angle (backward tilting (°))
3
°
Maximum allowable working angle (sideward tilting (°))
1.5
°
1.12 Falling hazard
1) The workers on the platform must put on all safety devices and fix the accepted rope anchorage
point with the safety strap hook in the operation process. Each rope anchorage point is only
applicable to one clevis.
2) Do not climb on or sit on the guard rail of the platform. Please stably stand on the platform base
plate in any time.
3) Do not climb down the platform when it is lifted.
4) Keep the platform floor free from debris.
5) Please shut down the entrance door before the operation.
6) Do not run the machine when the guard rail is not correctly installed or the safe operation cannot
be insured by the entrance door.
7) Do not get in and out of the platform, except the machine is folded.
1.13 Hazard
1) Pay attention to the items within the sight line and the blackspot when starting or running the
machine.
2) Pay attention to the position of the extending platform when moving the machine.
3) Check the workstation to avoid any overhead barrier or other possible hazards.
4) Pay attention to the crush danger when holding the guard rail of the platform.
5) The user must follow the service rules for the personal protection equipment, made by the owner,
the service rules for the workstation and the laws and regulations made by the government.
6) Please observe and follow the traveling arrow and the turning direction arrows on the platform
controller and the platform’s label and nameplate.
7) Do not operate the machine on the line of any crane or movable overhead machine, unless the
crane controller is locked and/or the potential bump prevention measure is taken.
8) Avoid dangerous driving or careless operation when running the machine.
9) The platform can be lowered only when there are no person and barriers below the platform.
10) Limit the traveling speed according to the ground status, traffic jam, road grade, person position
and any other possible bump factors.
1.14 Component damage hazard
1) Do not charge the battery with any above 24V battery charger.
2) Do not use the machine as an earth wire in the process of welding.
1.15 Explosion and fire hazard
Do not operate or charge the machine at the location with possible inflammable or explosive gas or
particles.
1.16 Machine damage hazard
1) Do not use any damaged or failed machine.
2) Please make an absolute operation check and test all functions before each shift. Attach a mark
on the damaged or failed machine immediately and stop the operation.
5