LGMG S0507SDTCE10, Руководство по эксплуатации и обслуживанию

Страница: 69 / 79

Operation and Maintenance Manual of Aerial Work Platform
4) Lower the platform height until the safety prop completely contacts the shaft sleeve.
Crush hazard
Be sure to put your hand on correct position of the safety prop when lowering the platform.
1) Turn the key switch to the OFF position.
2) Mark and separate the platform controller connector.
3) Connect the platform controller connector to the cable connector of main harness.
4) Open the lower limit switch base cover and unplug the connector of lower limit switch.
5) Switch the key switch to the platform controller.
6) Slightly raise the platform and recover the safety prop to the installation position.
7) Press the lifting function selector button on the platform controller on the ground and lower the
platform until it is folded.
Result: the diagnosis screen displays the code 18, the alarm is outputted and the lifting function
response is normal. The function of machine is normal.
Result: the diagnosis screen dose not display the code 18, no alarm is outputted and the lifting function
gives no response. In such case, the limit switch shall be replaced.
8) Press the drive function selector button and try to run the machine.
Result: the diagnosis screen displays the code 18, the alarm is outputted, but the turning function and
the driving function are disabled. The function of machine is normal.
Result: the diagnosis screen dose not display the code 18, the alarm is outputted and the turning and
driving function are enabled. In such case, the limit switch shall be replaced.
9) Press the lifting function selector button to raise the platform by about 0.3m.
Result: the diagnosis screen displays the code 18, the alarm is outputted and the lifting function is
enabled. The function of machine is normal.
Result: the diagnosis screen dose not display the code 18 and the alarm is outputted. In such case, the
limit switch shall be replaced.
10) Raise the platform until the hollow protector is stretched.
Result: the diagnosis screen dose not display the code 18 and the alarm is outputted. The function of
machine is normal.
Result: the diagnosis screen displays the code 18 and the alarm is outputted. In such case, the limit
switch shall be replaced.
11) Lift the platform to the height about 3.2m away from the ground.
12) Lift the safety prop, move it to the center of the scissor sleeve center and rotate it upward until it is
vertical.
13) Lower the platform height until the safety prop completely contacts the shaft sleeve.
Warning: crush hazard
14) Turn the key switch to the OFF position.
15) Remove the platform control line connected to the main chassis harness.
16) Resume the connection between the platform controller connector and the main chassis harness.
17) Connect the platform control connector.
18) Safely and correctly connect the connector of lower limit switch.
19) Well install the lower limit switch box.
20) Switch the key switch to the platform controller.
21) Slightly raise the platform and recover the safety prop to the installation position.
65