13
LGB cars with lighting or sound
electronics.
To remove the cover of the sock-
et, pull it straight out. If the cover
is tight, gently use a small straight
screwdriver to pry it out. (Do not
pull out the rectangular outer
housing.)
Power Supply
Attention!
For safety and reliabil-
ity, operate this model with LGB
power supplies (transformers,
power packs and controls) only.
The use of non-LGB power sup-
plies will void your warranty.
Use this model with LGB power
supplies
with an output of more
than 1 amp.
For more information
on LGB power supplies for indoor,
outdoor and multi-train operation,
see the LGB catalog.
Attention!
After extended opera-
tion, this model may leave carbon
dust or other debris around the
track. This dust and debris can
stain carpet and other materials.
Consider this when setting up
your layout. Ernst Paul Lehmann
Patentwerk and LGB of America
are not liable for any damages.
SERVICE
Do-It-Yourself Service Levels
Level
- Beginner
Level
- Intermediate
Level
- Advanced
Attention!
Improper service will
void your warranty. For quality
service, contact your authorized
retailer or an LGB factory service
station (see
Authorized Service
).
Hint:
Additional expert instruc-
tions for many LGB products are
available at www.lgb.com.
Lubrication
The axle bearings should be lubri-
cated occasionally with a small
amount of LGB Maintenance Oil
(50019).
Cleaning
This model can be cleaned exter-
nally using a mild detergent and
gentle stream of water. Do not
immerse this model.
Attention!
This model is
equipped with sound electronics.
Do not expose the speaker direct-
ly to water.
Replacing the light bulbs
Front/Rear lights:
Pull the
lantern housing away from the
model. Remove and replace the
bulb. Reassemble.
Cab light:
Using tweezers,
remove and replace the bulb.
Replacing the traction tire
- The gearbox should be removed
to replace the traction tire.
- On the bottom of the gearbox
are six screws. Remove the first
and last screw.
- Carefully pull the gearbox out of
the chassis.
-
Use a small, straight-blade
screwdriver to replace the trac-
tion tire:
- Pry the old traction tire out of the
wheel groove.
- Gently insert the new traction
tire into the wheel groove.
- Make sure that the traction tire is
seated properly in the wheel
groove.
- Reassemble.
Maintenance parts
50019 Maintenance Oil
51020 Gear Lubricant
62204 Standard Motor with
Long Shaft
63120 Brushes, Assembled,
14 mm and 16 mm,
8 pieces (2 packages
needed)
63218 Standard Pick-Up
Shoes, 2 pieces (2 pack-
ages needed)
68511 Plug-In Bulb, Clear, 5 V,
10 pieces
69104 Traction Tire, 37.5 mm,
10 pieces
INSTRUCTIONS FOR
ADVANCED USERS
MTS Onboard Decoder
Programming functions
You can program numerous func-
tions of the onboard decoder to
