17
206-4278
EZ-Manager Wizard
Pro:Centric Mode
Media Type
Addresss
Port
GEM
IP
< >
Back
Next
Exit
Pro:Centric Manual Configuration
255
0
255
255
255
Pro:Centric Manual Configuration Screen with
IP Media Fields
4
3
2
1
(Continued from previous page)
IP Configuration
a) In the Media Type
field,
use the Left/Right arrow keys to
select
IP
.
Note:
By default, the Pro:Centric Manual Configuration
screen initially shows RF configuration fields. When you
select “IP” as the Media Type, the Data Channel and
Signal Strength/Quality fields are replaced with IP Address
and Port fields
.
b) I
n the Address and Port fields, either key in or use the
Left/Right arrow keys to select the appropriate values for
the Pro:Centric server IP address and port number.
The IP address must match the IPv4 multicast address
and the port number must match the port number that is
set in the Pro:Centric server.
4. Once all fields are completed as required, you
have two
options (see also note below):
• To save the data entered and exit the wizard, use the arrow
keys to select
Exit
and then press
OK
. In the subsequent
pop-up confirmation window, select
Save and Exit
, and then
press
OK
once more. The Pro:Centric application and/or
E-Z Installation data will be downloaded to the TV at a later
time. This option is useful, in particular, if the Pro:Centric
server has not yet been configured.
• To initiate a real-time download of Pro:Centric application
and/or E-Z Installation data, use the arrow keys to select
Next
, and then press
OK
.
The EZ-Manager Wizard will proceed with the remaining
Pro:Centric application and/or E-Z Installation data down-
load steps, as shown on the Processing the Pro:Centric
Configuration screen.
Note:
With RF configuration, Pro:Centric server data must be
present on the RF channel selected as the TV’s Data Channel
in order for you to select “Next” (you will see a “Data channel
found” message below the Signal Quality indicator). With IP
configuration, Pro:Centric server data must be present via the
wired LAN cable connection in order for you to select “Next”
(you will see a “IP server found” message below the Port field).
When the Pro:Centric configuration is complete, an EZ-Manager
Configuration Complete screen is displayed, and after 10
seconds, the wizard exits, and the TV turns OFF.
Note:
With the EZ-Manager Configuration
Complete screen on
display, you also have the option to manually turn off or reboot
the TV. If desired, select
Turn Off
or
Reboot
, respectively, and
then press
OK
on the Installer Remote.
EZ-Manager Wizard
EZ-Manager Configuration Complete
Pro:Centric Application
Maintenance Files
GEM application downloaded
LX570H_Config.tlx
Installed Components
2
1
3
The TV will turn off in 3 second(s).
4
Reboot
Turn Off
EZ-Manager Wizard
Processing the Pro:Centric Configuration...
Application files
Maintenance files
Warning - Do not remove AC power or the signal cables during these steps
1%
In progress...
Pending...
Retrieving files from data channel 75
4
2
1
3
Downloading the Pro:Centric application files takes a few minutes.
Please wait...
EZ-Manager Wizard
Pro:Centric Mode
Channel Number
Signal Strength
Signal Quality
0%
GEM
1
< >
Back
Next
Exit
Pro:Centric Manual Configuration
0%
No signal
Are you sure you want to exit the wizard?
If you select ‘OK’ now, your settings will be lost
and you will exit the setup wizard.
This window will close and you will be returned to
the previous page automatically in 2 seconds.
Save and Exit
Cancel
OK
!
4
3
2
1
EZ-Manager Wizard (Cont.)
