34
206-4261
(Continued from previous page)
5. (PTC cloning only) Transfer the auto-tuned/edited channel lineup (if
applicable) and TV setup menu settings to the PTC: 2-5-5 + MENU
Mode
Note: This step is essential for successful cloning using a
TLL file. Without this step, the PTC will not contain any
channels or TV setup menu settings.
Note: The maximum number of channels (analog, digital,
and Aux inputs) that can be transferred to the PTC is 141.
An attempt to transfer more than 141 channels of any
combination will result in a PTC Channel Map of exactly 141
channels; any extra channels will not be available in the PTC
Channel Map. For example, if you enabled three Aux inputs
in the Installer Menu and Auto Tuning found 141 channels,
you must edit the TV channel lineup to decrease the number
of analog/digital channels to (at most) 138 in order to
accommodate the Aux inputs in the PTC Channel Map. Note
that Aux inputs will appear between the highest analog and
lowest digital channel number in the PTC Channel Map.
Note: If you did not run Auto Tuning, no analog or digital
channels will be transferred to the PTC Channel Map upon
completion of this step. In this case, the only channels in the
PTC Channel Map will be any enabled Aux inputs.
a) After the TV channel lineup has been edited and channel label icons
added, tune to the channel (source) for which you wish to transfer TV
setup menu settings.
b) Access the Installer Menu, and press
2-5-5
+
MENU
on the Installer
Remote to initiate the transfer of the Master TV Setup to the PTC.
The TV exits the Installer Menu and then tunes through the channels
in the channel lineup during the transfer. When the transfer is com-
plete, the TV tunes back to the channel that was tuned before the
transfer began.
Note:
Scan Mode is not functional until the TV setup is transferred.
6. (PTC cloning only / Optional) Add Custom Channel and Aux Input
Labels: 2-5-4 + MENU Mode
2-5-4 + MENU Mode enables you to add/edit channel icons and custom
text labels in the PTC Channel Map once the Master TV Setup has been
transferred as described in the previous step.
Access the Installer Menu, and press
2-5-4
+
MENU
on the Installer
Remote. Add/edit custom text labels and/or change icons for the
Channel-Time on-screen displays (see 2-5-4 + MENU procedural
information on page 36). Note that broadcast digital channels often
already have a broadcaster generated label. When you are finished,
press
MENU
to exit 2-5-4 + MENU Mode.
Custom Master TV Setup (Cont.)
DIGITAL 19-3
WXYZ
MONO STEREO SAP
Custom Text Label “WXYZ” created
in 2-5-4 + MENU Mode.
(Continued on next page)
