Lexmark X500N, Руководство по обслуживанию

Страница: 111 / 244

Diagnostic aids
3-3
Lexmark confidential until announce edited 1/4/2007 7100-XXX
Retrieving, printing and restoring the MFP settings
Printing the maintenance and configuration pages
Before replacing the engine controller board or the system / RIP board, print out the maintenance and
configuration pages. These page contain the MFP setting information that will need to be reset on the new
board.
Printing the maintenance page
1. in Ready mode, press . The MFP will enter the admin menus.
2. Press
twice to scroll to the Reports menu.
3. Press
.
4. Press
once to scroll to the Maintenance Page item.
5. Press and hold . The maintenance page will print out.
Printing the configuration page
1. in Ready mode, press . The MFP will enter the admin menus.
2. Press
twice to scroll to the Reports menu.
3. Press
.
4. Press
XX times to scroll to Configuration Page.
5. Press and hold . The configuration page will print out.
Setting the country code
The country code must be reset when the system/RIP board is replaced. The country code setting
determines which communication protocols, compression settings, and signal strength settings will be used
for a given country or region. Failure to reset the country code can render the fax functionality unusable.
To set the country code, perform the following steps:
1. in Ready mode, press
to enter the MFP menus.
2. Use the
or keys to scroll to the Administration menu.
3. Press
to select the Administration menu.
4. Use the
or keys to scroll to the Country menu.
5. Use the
or keys to scroll to the desired country or region.
6. Press
to select and confirm the country or region.
Scanner calibration and registration
The X5xx scanner is self-calibrating. Scanner calibration occurs every time the MFP is started. in addition,
calibration is performed before a scan, copy or fax action is performed.
Top edge registration is performed when the MFP is powered on and before every scan, copy, or fax. Right
and left edge registrations are performed only when the MFP is started.
If the scanner fails to calibrate, 006 Service Call / Scanner Unit will be displayed. Should this error display,
see
“Flatbed service check” on page 2-41 .