Lexmark Pro910 Series, Руководство по обслуживанию

Страница: 30 / 118

2-10
Service Manual
Lexmark Pro910 Series
Go Back
Previous
Next
USB error An error was detected in USB
hardware, or invalid results occurred
in USB code. Technical Support Center:
Unplug the printer from the electrical
outlet; wait a few seconds, then plug
the printer back in and turn the power
on. If the problem remains, then
replace the USB cable.
Service:
Replace the USB cable. If the problem
remains, then replace the system
board. See
“System board removal”
on page 4-35 .
Data abort error Firmware attempted to load or store to
an invalid address. Technical Support Center:
Unplug the printer from the electrical
outlet, wait for 10 seconds, and then
plug the printer back in. If the problem
remains, then replace the USB cable.
Service:
Replace the system board. See
“System board removal” on
page 4-35
.
Invalid processor mode error Indicates the ARM processor was in
an incorrect mode to perform the
requested operation. Technical Support Center:
Unplug the printer from the electrical
outlet, wait for 10 seconds, and then
plug the printer back in. If the problem
remains, then replace the USB cable.
Service:
Replace the system board. See
“System board removal” on
page 4-35
.
Temperature error There is a problem determining
temperature. Technical Support Center:
Unplug the printer from the electrical
outlet, wait for 10 seconds, and then
plug the printer back in. If the problem
remains, then replace the printhead.
Service:
1. Clean the printhead contacts. If
the problem remains, then replace
the printhead.
2. Check for bent contacts on the
tank contact card. If the contacts
are bent, the replace the tank
contact card. See
“Tank contact
card removal” on page 4-18 .
If the problem remains, then replace
the system board. See
“System
board removal” on page 4-35 .
Error table
Error Description Action