Lexmark 5060-00x, Руководство по обслуживанию, Страница: 64 / 490

2-30
Service Manual
5060-00 x
272 Paper Jam Clear
Paper Path Leave Job in Finisher
area 5 Primary: Media is jammed in the 5-bin mailbox option. Open
the rear door of option to access the jammed media.
Secondary: If sheets have been accumulated to be stapled
when the jam is detected, the printer alternately flashes the
primary and secondary messages indicating the
accumulated sheets should not be removed during jam
clearing.
Note : When the secondary message is displayed, if the
accumulated sheets are removed the printer will not reprint
these sheets. Also if the print job is completed, the portion of
the job printed after the jam will not be stapled.
280 Paper Jam Clear
Paper Path Leave sheets in
Finisher
area 5 Primary: Media has jammed in the finisher option. Open the
finisher side door to top cover to access the jammed pages.
Secondary: If sheets have been accumulated to be stapled
when the jam is detected, the printer alternately flashes the
primary and secondary messages indicating the
accumulated sheets should not be removed during jam
clearing.
Note : When the secondary message is displayed, if the
accumulated sheets are removed the printer will not reprint
these sheets. Also if the print job is completed, the portion of
the job printed after the jam will not be stapled.
282 Staple Jam
Check Stapler
283 Staple Jam
Check Stapler
Remove Job from
Finisher These messages are displayed when the stapler device
detects a paper jam.
282 Staple Jam indicates that a staple jam has been
detected during normal stapler operation such as when
printing and stapling jobs.
283 Staple Jam indicates that a staple jam has been
detected during a priming operation. No secondary
message will be displayed.
Note : After the error has been cleared, the printer does not
reprint any pages which existed in the accumulator for
stapling.
The following actions can be taken while either the primary
or secondary messages are displayed:
Press Go to initiate priming and resume printing.
Note : Use of the “Sub error code table” on page 2-17
may help in diagnosing 282 and 283 Errors.
Setup Required This message is displayed when the printer has detected at
POST, that packing material is still installed and must be
removed. The user should verify that the machine is
properly setup.
Press Go and Reflash Code.
A Alignment = x . x * This message is displayed when an ITU Alignment
Procedure is in process and the printer is prompting the
user for the
x ( x =A through L) alignment value. Alignment
values for A through L (= x . x *) -7 to +7 in 0.5 increments.
• Enter the alignment value and press Select to continue
to the next alignment value.
• To abort the alignment operation press Go or Return .
User primary
message User secondary
message
Explanation