Configuration and diagnostics software - Sensor Studio
Leuze electronic GmbH + Co. KG
BCL 8
44
9.5.4 Host interface tab
Figure 9.9:
Host Interface
tab
Select the desired baud rate, the stop bits, the data bits, the parity and various transmission modes here.
The parameters are not active until these settings have been transferred to the code reader (standard
procedure).
The desired acknowledgment settings are also to be set in this selection window.
Properties dialog box (Framing Protocol)
Figure 9.10: Standard settings of the Properties dialog box (FRAMING PROTOCOL)
Here, you can change the address settings and the protocol for sending and receiving.
NOTE
To be able to continue to communicate with a device following a parameter transfer, you may
need to make appropriate adjustments to the communication properties of the device in the
Sensor Studio
configuration software.
