Lenze EPL10200, Инструкция по монтажу

Страница: 39 / 57

Troubleshooting and fault elimination
?
?
MA DrivePLC DE/EN/FR 1.0
17
Display Remedy Cause Error
keypad PC
1)
EF a
63 Communication error to
CAN-IN2 CAN-IN2-object receives faulty data
or communication is interrupted
l
Plug-in connection - bus module
Ø
Check FIF
l
Check transmitter
l
Increase monitoring time under
C0357/2 if necessary
EF a
64 Communication error to
CAN-IN1 with event or time control CAN-IN1-object receives faulty data
or communication is interrupted
l
Plug-in connection - bus module
Ø
Check FIF
l
Check transmitter
l
Increase monitoring time under
C0357/3 if necessary
EF a
65 BUS-OFF
(many communication errors
occurred) The Drive PLC has received too
many incorrect telegrams via the
system bus and has been
disconnected
l
Check whether bus terminator
available
l Shield control of the cables
l Check PE connection
l Check bus load, if necessary,
reduce the baud rate
(( a
91 External fault (TRIP-Set) A digital signal assigned to TRIP set
has been activated Check external encoder
+ a
105 Internal fault Contact Lenze
PF a
74 Fault in program execution A fault was detected in the program. Send the Drive PLC with the data
set (on diskette) to Lenze.
PJ a
79 Initialisation error during transfer of
parameter set
l
A fault was detected during the
transfer of the parameter set to
the Drive PLC.
l Parameter set does not match
Drive PLC
Correct the parameter set.
3 a
75 Internal fault Contact Lenze
3 a
72 Wrong PAR1 transfer when using
the keypad/PC. PAR1 is defective. Repeat data transfer or load Lenze
settings
3 a
79 Internal fault Contact Lenze
1)
LECOM fault number
Show/Hide Bookmarks