Lenovo ThinkServer TS140, Руководство по техническому обслуживанию аппаратной части

Страница: 86 / 132

9. Connect one end of the signal cable to the hard disk drive and the other end to an available SATA
connector on the system board. See “Locating parts on the system board” on page 17. Then, locate an
available five-wire power connector and connect it to the hard disk drive.
Figure 52. Connecting a SATA hard disk drive
Replacing the primary hard disk drive
Attention: Do not open your server or attempt any repair before reading and understanding “Safety information”
on page iii and “Guidelines” on page 39.
This topic provides instructions on how to replace the primary hard disk drive.
Note: For a 2.5-inch hard disk drive or solid-state drive, install the drive into a 3.5-inch to 2.5-inch drive
adapter first. See “Installing the 2.5-inch solid-state drive or hard disk drive” on page 49.
To replace the primary hard disk drive, do the following:
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. Remove the server cover. See “Removing the server cover” on page 41.
3. Locate the primary hard disk drive. See “Locating parts on the system board” on page 17.
4. Disconnect the signal cable and the power cable from the rear of the hard disk drive.
72
ThinkServer TS140 Hardware Maintenance Manual