NOTE: DIAGRAMS AND ILLUSTRATIONS ARE REPRESENTATIVE AND ARE NOT DRAWN TO SCALE.
www.LennoxHearthProducts.com
27
LENNOX HEARTH PRODUCTS • RHAPSODY™ LINEAR DIRECT-VENT GAS FIREPLACES (MODEL RHAP54N) • INSTALLATION INSTRUCTIONS
INSTALLINg fIREPLACE COMPONENTS
(CONTINUEd)
WARNINg
Any safety screen or guard
removed for servicing the appli-
ance must be replaced prior to
operating the appliance.
AVERTISSEMENT
Tout écran ou protecteur retiré
pour permettre l’entretien de
l’appareil doit être remis en
place avant de mettre l’appareil
en marche.
WARNINg
do not operate appliance with
the glass front removed, cracked
or broken.
AVERTISSEMENT
Ne pas utiliser l'appareil si le
panneau frontal en verre n'est
pas en place, est craqué ou brisé.
CAUTION
RISk Of PERSONAL INjURy
OR PROPERTy dAMAgE.
• do NOT abuse glass door by striking or
slamming shut.
• Handle glass with extreme care! Glass is
susceptible to damage; do NOT scratch or
handle roughly while reinstalling the glass
door frame.
•
Never operate fireplace with glass door
assembly removed.
These direct-vent appliances are designed
to operate only when glass door assem-
bly is installed. Generally, the glass door
assembly should not be removed, except
when access to components within the
firebox is required.
•
do not attempt to substitute the materials
used on these doors, or replace cracked
or broken glass.
• The glass door(s) of this appliance must
only be replaced as a complete unit as pro-
vided by the manufacturer. do not attempt
to replace broken, cracked or chipped glass
separately.
WARNINg
HOT gLASS WILL CAUSE BURNS.
dO NOT TOUCH gLASS UNTIL COOLEd.
• Remove glass door assembly (and
optional bezel)
only when fireplace is
Off and COLd.
•
do not attempt to touch the front enclo-
sure glass with your hands while the
fireplace is in use.
• The glass on the front of the fireplace
reaches ExTREMELy HIgH temperatures
and can cause severe burns if touched.
Even after the gas is turned off, fireplace
surfaces remain extremely hot.
INSTALLATION/REMOVAL
Of gLASS dOOR ASSEMBLy
ANd OPTIONAL BEZEL
Note: If installing the optional bezel, install
the glass door assembly first; then the bezel.
When removing components, remove the
optional bezel before removing the glass
door assembly.
Installation of glass door Assembly
1. While holding the door assembly by the
side edges, hook the top edge to the fire-
place, and then swing the bottom edge in
toward the fireplace, taking care not to
damage the glass (Figure 27-1).
2. Align the screw holes below the door
assembly with the holes in the fireplace,
and secure using the (3) provided screws.
Reverse these steps to remove the glass door
assembly.
(Continued on next page)
Figure 27-1
glass door Assembly
rating plate and lighting instructions
are attached to door bracket.
