CLEANING AND DISINFECTION OPERATIONS
N.B.: If using chemical disinfectants, follow the manufacturer’s instructions exactly.
•
The cannula and the aspirated flow manual command are
sterile
,
disposable
products and must be replaced
after every application.
•
The antibacterial disposable filter must be replaced after every application.
•
Never leave the appliance in water or submerged; clean the external casing of the appliance using only a
damp cloth with detergent (non abrasive).
Note: if you experience faults or malfunctioning problems different to those listed above, always and
exclusively contact authorised assistance centres.
PROBLEMS, CAUSES AND SOLUTIONS
PROBLEMS
POSSIBLE CAUSES
SOLUTIONS
Excessive noise.
Damaged pump or blockages in the
internal aspiration circuit.
Send to the assistance circuit.
The unit switches on but does not aspirate. - Damaged pump.
- Vacuum regulator fully open. Connection
tubes disconnected and/or badly
connected, broken connection tubes.
Container not in a vertical position, full, or
defective overflow valve. Possible
blockage of the hydraulic circuit inside the
unit.
- Send to the assistance circuit.
- Check the position of the vacuum
regulator. Check the connections and the
integrity of the tubes. Position the
container in a vertical position, check the
overflow valve (blocked) and/or replace
the silicon tubes.
The vacuum rate cannot be regulated. Damage to the internal hydraulic system
or blockage of the connection tubes to
the aspiration unit.
Send to the assistance circuit.
When the appliance is switched on, the
protection fuse always trips.
Pump probably damaged or in shortcircuit. Send to the assistance circuit.
The vacuum gauge does not work. Liquid penetrating the pneumatic circuit. Send to the assistance circuit.
TECHNICAL CHARACTERISTICS
Professional portable medical device for secretion removal, suitable for fixed and transportable use.
Complete with flame retardant ABS V0 casing and piston-cylinder electrical compressor lubricated for life.
Risk class under Directive 93/42/EEC:
IIa
Suction class:
High vacuum / High flow
Voltage:
12VDC
Absorption:
3A
Adjustable vacuum level:
from 0 to –0.85 bar (-85KPa)
Vacuum gauge precision class:
2.5% under UNI EN 837
Air flow:
30 lt/min operating without restri/– 10 %
Temporary use:
max. 45 minutes
Dimensions:
38 (length) x 13.5 (width) x 26 (height) cm (1000ml Vessel)
38 (length) x 13.5 (width) x 35 (height) cm (2000ml Vessel)
Weight:
4.5 kg approx (1000ml Vessel)
4.7 kg approx (2000ml Vessel)
Noise level:
55dBA
Multi-voltage switching battery charger:
PRI: 100 ÷ 240V~ 50 – 60Hz
SEC: 14VDC 4.28A
Internal battery:
12VDC 4Ah Lead, hermetic
Battery charge duration:
45 minutes at maximum suction power
Fuse for cigarette lighter power supply cord:
F6.3A - 250V delayed fuse - dimensions Ø 6.3 x 30 mm
Operating conditions:
Temperature:
min. 0° C; max 40° C
Air humidity:
min. 10 %; max 95 %
Storage conditions:
Temperature:
min. –10° C; max 50° C
Air humidity:
min. 10 %; max 95 %
%
Operating-storage conditions:
min. 690 hPa; max 1060 hPa
21
Содержание Aspimed 1.9
Страница 37: ......