Leister UNIROOF 300, Руководство пользователя, Страница: 26 / 59

26
Symbol drive/welding speed [m/min or ft/min]
Symbol air temperature [°C or °F]
Symbol air volume [%]
Welding temperature too low, heating process up arrow and
progress bar show that the desired higher temperature has not yet
been achieved. The flashing number above the progress bar desig-
nates the currently achieved actual value (345); the value to the right
of the bar (440) shows the nominal value of the selected welding
profile or of the individual setting.
Welding temperature too high, cooling process down arrow
and progress bar show that the desired
lower temperature
has not
yet been achieved. The flashing value above the bar designates the
currently achieved actual value (485); the value to the right of the
bar (440) shows the nominal value of the selected welding profile or
of the individual setting.
Symbol for Cool-down mode
Symbol for hardware error message.
The device is no longer ready for operation. Contact an authorized
Leister Service Center. (Note the respective error code in Section
Warning and Error Messages).
Symbol for Hardware error message (heating element is defective).
The device is no longer ready for operation. Contact an authorized
Leister Service Center.
Symbol for Overtemperature warning message. Allow the device
to cool down.
During operation, the setpoints of the welding parameters (drive in m/min or ft/
min, temperature in degrees Celsius or Fahrenheit, air volume in percent and, if
applicable, information notes (see Info Mode: Show current values [10.10]) are
displayed.
Use the Minus/Plus (32) buttons to switch between the welding parameters. By
pressing the Confirm (33) button, the respective parameter can be individually
adjusted with the Minus/Plus (32) buttons.
9.5 Display symbols of the work display (Display 41)