Leica DM1000 LED, Руководство по эксплуатации

Страница: 58 / 178

58
14. Nachrüstungen
Fig. 57 UCA/P condenser disk
1 Light ring „small, PH“
2 Light ring „large“ for large holes
3 a, b DIC condenser prism
4 Marking for assembly of DIC condenser prisms
5 Marking K on the prism mount
6 Guide groove for prism
7 Adhesive label
8 Centering screws
9 Rotatable axis
10
λ
or
λ
/4 compensator
Attention:
Before fitting the disk into the condenser, make
sure that neither of the centering screws is
sticking out at the side.
• Fasten the condenser disk with the axis
screw, check that the disk rotates properly
through 360
° .
• Affix the condenser with the condenser’s
clamping screw.
Condenser UCA/P
• Unscrew the fastening screw of the disk. This
is found on the underside of the condenser
and must be fully screwed out.
• Turn back the centering screws until the light
rings,
λ
- and
λ
/4 - compensator* and lens*
2.5x can be inserted.
The largest hole is for brightfield
observation (= BF), the slightly smaller ones
are light rings,
λ - and λ /4 - compensator or
lens* 2.5x.
Notes:
If you use a smaller hole for brightfield, the
maximum illumination aperture cannot be used.
The lettering (e.g. DF, PH 1 ....., λ ) must point
upward , the
λ
or
λ
/4 compensators must be
inserted with the correct orientation: The notch
must point toward the center of the disk! The
lettering of the components should
correspond
to the marking at the opposite position (outer
edge of the disk).
Attention:
Before fitting the disk into the condenser, make
sure that neither of the centering screws is
sticking out at the side.
• Fasten the condenser disk with the axis
screw, check that the disk rotates properly
through 360
° .
• Affix the condenser with the condenser’s
clamping screw.
! !