2009-2013
FLH
RENEGADE
9.
See Fig. 3
. Center body to differential from side
to side until equal measurements are achieved on
both sides.
10.
See Fig. 4
. Center body front to back measuring
from rear axle flange to front of fender until equal
measurements are achieved on both sides.
11. Allow at least 1/2” gap between front of seat shell
and side cover for side cover removal.
12. Tighten hardware in this order: seat shell bolts,
front body mount bolts into seat shell; torque front
body mount bolts to
6 ft-lbs
.
13. From underside of body, drill a 1/4” hole in body
through each of four mounting tabs. Keep hole
centered in slots on frame.
14. Fasten body to Lehman frame as follows: Head
of bolt will be inside trunk.
•
(4) 1/4” x 1-1/2” Button Head Bolts- CS4031
•
(4) 1/4” x 1 1/4” Fender Washers- CW2108
•
(4) Foam Sealing Washers- FG1002
•
(4) 1/4” Flat Washers- CW2007
•
(4) 1/4” Lock Nuts- CN3041
15. Recheck body alignment; adjust accordingly.
16. Tighten body mount brackets to frame straps.
Torque bolts to
8 ft.-lbs
.
17.
See Fig. 5.
Install upper body braces (LB1235)
by attaching slotted side on top of Lehman frame us-
ing the following hardware. Leave hardware loose.
•
(2) Body Brace– LB1235
•
(2) 5/16” x 1” Bolts– CB1161
•
(2) 5/16” Lock Washers– CW2047
•
(2) 5/16” Flat Washers– CW2010
18. Slide bracket against trunk, mark and drill 1/4” hole.
19. Attach bracket to body using the following hardware.
•
(2) 1/4” x 1-1/2” button head bolts- CS4031
•
(2) 1/4” x 1 1/4” fender washers CW2108
•
(2) Foam Sealing Washers FG1002
•
(2) 1/4” Flat Washers- CW2007
•
(2) 1/4” Lock Nuts- CN3041
20. Tighten 5/16” hardware into place on trike frame.
21. Verify all body mounting hardware is tight.
Fig. 3
Fig. 4
Equal measurements on both sides
Equal measurements on both sides
BODY CONTINUED
33
Fig. 5
Body brace attached
to frame
