2009-2013
FLH
RENEGADE
7. Use original cross-over airline to connect “tee” to air
valve. Use new air line to connect two shocks to-
gether.
8.
See Fig. 4.
Air valve plate for front and rear shocks
must be removed and relocated. Recommended loca-
tion is on right side of trike behind air deflector in loca-
tion shown.
9.
See Fig. 5
. Air valve plate will be fastened with
stainless nuts on both sides of deflector.
10. Route airlines along bottom side of upper frame tube
and back to rear shocks.
11. Secure airline to frame with cable ties as needed.
12. Charge system with air to 20 psi and check for leaks.
13.
See Fig. 6
. Install Shock to lower threaded shock
plate. Torque bolt to
40 ft.-lbs
. Secure bolt with lock
nut.
•
(2) 1/2” X 2 x 1/4” Bolts– CB1411
•
(2) 1/2” Flat Washer– CW2025
•
(2) 1/2” Lock Nut
14.
See Fig. 6
. Raise differential and install top of shock
To frame using the following hardware. Shock should
run parallel to frame tube when viewed from rear.
Torque shock bolts to
40 ft.-lbs
.
•
(2) 1/2” X 2 x 1/4” Bolts– CB1411
•
(2) 1/2” Lock Washer– CW2060
•
(2) 1/2” Flat Washer– CW2025
Fig. 5
Fig. 6
Fig. 4
Relocate air valve plate
Air valve plate
mounting hardware
FRAME AND SUSPENSION
25
