2009-2013
FLH
RENEGADE
ABS Systems
1.
See Fig. 1.
Disconnect OEM rear brake line (black)
from ABS unit “MR”. Route brake line along lower
frame tube and above swingarm. This line will be
used for the rear brake system.
2.
See Fig. 2.
Re-install banjo bolt with spacer
(S001067) in ABS unit “MR” and tighten.
3.
See Fig. 1.
Disconnect OEM rear brake line (silver)
from ABS unit “R” and discard (brake line was dis-
connected from rear caliper during motorcycle disas-
sembly).
4.
See Fig. 2.
Re-install banjo bolt with spacer
(S001067) in ABS unit “R” and tighten.
5.
See Fig 3.
Locate ABS front wheel sensor plug un-
der left side of fairing and disconnect. Secure longer
sensor plug to fairing wire bundle with cable tie
(CT1026).
6.
See Fig. 4.
Locate ABS rear wheel sensor plug (left
side of ABS unit). Disconnect plug, remove sensor
from right-side axle and discard.
7. Place ABS warning label above warning light indica-
tors on fairing.
BRAKE SYSTEMS-ABS MODELS
22
Fig. 1
Fig. 2
Fig. 3
Fig. 4
From ABS to caliper (silver)
From Mas. Cyl. to ABS (black)
R
MR
Banjo bolt spacer (S001067)
R
MR
ABS front wheel sensor plug
ABS rear wheel sensor plug
