2009-2013
FLH
RENEGADE
NOTE:
Swingarm pivot shaft components are different between
2009-10 and 2011+ models. Be sure to use the correct procedure
for your specific model year. See Fig. 1. Swingarm pivot shaft
bushings for 2011 models (S001661) will have a larger inside di-
ameter.
2009-2010 Models
NOTE: If all original components of H-D swingarm are in good
working order, they may be re-used.
1. Press bearing assemblies out of HD swingarm using appropriate
press collar. Refer to HD service manual.
NOTE: Make sure swingarm bore is clean where bearing will
be pressed in.
2. Press bearings into Lehman swingarm following H-D service man
ual procedure (H-D tool # HD-45327). H-D tool will set bearings at
correct location in Lehman swingarm collar.
3.
See Fig. 1 & Fig 2
. OEM cup washers will be replaced by new
swingarm reinforcement bushings (S001346-LH, S001347-RH &
S001315).
4.
See Fig. 3.
Install RH swingarm reinforcement bushings (S001347 & S001315) into original rubber mounts. Be
sure to align offset in mount and bushings.
5. Install Lehman swingarm with word “TOP” (stamped into swingarm collar) facing upward.
6.
See Fig. 3
. Assemble parts for LH side (S001346 & S001315) as shown.
7.
See Fig. 3
. Re-install LH swingarm fork bracket. Apply Loctite 242 and torque bolts to
55 ft.-lbs
.
8.
Apply Loctite 242 to pivot shaft nuts and install. Torque swingarm pivot shaft nuts to
55 ft.-lbs
and
reinstall chrome caps.
NOTE: Refer to HD service manual for swingarm installation procedures and torque specifications for spe-
cific model of motorcycle.
9.
Verify swingarm assembly moves freely with no side to side play. Light resistance when moving up
and down is normal.
Fig. 2
Fig. 3
INSTALLING LEHMAN SWINGARM
Fig. 1
11
