9
17. Once all the desired devices have been fully discovered, click on the checkbox next to each device that you want to move to
LMBR’s network. The LMBR begins the process of moving the device to the new Network ID and Channel of the LMBR, and the
checkbox will turn blue when complete.
IMPORTANT:
If you have more than one LMBR, be sure to select
only
the devices that you want to assign to this particular
LMBR. After completing assigning devices to this LMBR, you will repeat the process for each additional LMBR.
NOTE:
The LMBR may have to try several times to communicate with a device to get it to move to the LMBR’s network. You may
see failure messages in the log at the bottom. But the LMBR will keep trying until it has successfully moved all selected
devices. (If you click
Next
, that will stop the move process.)
Click the checkbox for each device you
want to add to the LMBR’s network. When
the box turns blue, it has been added
18. Once all of the selected devices have been moved, click
Next
. The
Room Assignment
dialog opens. This dialog provides the
ability to create rooms and areas, assign the various devices into those rooms, and finally pair the devices in that room so they
communicate with each other and not with devices in other rooms.
NOTE:
If you click
Finish
at this point, you can exit the Discovery wizard and then manually create rooms and move the
discovered devices into those rooms at a later point by dragging and dropping in the tree. You will also then have to pair
the devices after moving them. However, keep in mind that if you have more than one LMBR, you will have to restart the
Discovery wizard in order to configure any additional LMBRs that were not previously commissioned.
