14
Discover Wired Devices
Once the “Finished LMBC-650 discovery” message displays, click
Close
. The wired devices will now show up under the LMBC-650 in
the tree and can be edited like any other wired DLM devices.
To discover wired devices that are connected to a single LMBC-650, select the LMBC-650 in the Devices tree and click
Discover
in the
information section.
NOTE:
It is also possible to manually add devices under the LMBC-650 by selecting them from the
Add Devices
section of the
LMBC-650 information area. In this case, you will need to enter serial numbers and device IDs and synchronize the devices, the
same as you would for wired devices in a project that was created off-line. See the LMCS-100 Operation Manual for details.
VIEWING LMBR-650 AND WIRELESS NETWORK INFORMATION
If you select the
Networks
tab, each LMBR-650 that has been discovered will display in the Networks tree.
LMBR-650 Information
You can enter a
Description
and it will display in the tree. The
IP Address
can be edited, but if you do so, it would need to be changed
on the LMBR, so it is recommended you do not change it here, and instead .
If you click
Update Firmware
, a dialog opens displaying the version of firmware that was included when the current version of LMCS
was installed. It will also check and display the version in the LMBR itself, allowing you to update if a newer version has become
available.
IMPORTANT:
If you click
Factory Reset
, the LMBR will be reset back to default values. Not only will the Network ID and Channel be set
to defaults, but the security certificate will also be deleted. You must then create a
new
Site and rediscover the LMBR—you will
not
be
able to use your existing site. Therefore, use caution with this function.
If you click the
Configure
button, a dialog open that allows you change the IP address and other connection parameters, for Static IP
configuration. The reason for doing this is described in detail at the beginning of this section, on
