5-6
SIMULTANEOUS LAMINATING AND MOUNTING WITH
MOUNTING POUCH BOARDS
With the laminator unthreaded and free of any roll film:
1.
Set roller temperature to 350 degrees Fahrenheit.
2.
Open roll gap control handle (Large black knob on right hand side of laminator) by turning
clockwise until it stops completely.
3.
Switch speed selector switch (Black toggle switch on control panel) to
POUCH
laminating
position.
4.
Turn speed control potentiometer knob (Small black round knob on front of control panel) up
to maximum speed.
5.
Assemble item to be laminated into the mounting pouch as per manufacturers supplied
directions.
6.
Insert sealed edge into heated roller nip and press firmly until you feel the rollers “grab” the
mounting pouch.
7.
After the mounting pouch passes completely through the laminator, retrieve it as it exits and
lay it flat to allow it to cool for a few minutes.
CAUTION: DO NOT ATTEMPT TO
HURRY THE PROCESS BY PULLING ON THE BOARD. THIS COULD DAMAGE
THE DRIVE MOTOR ( AND VOID THE WARRANTY ) . LET THE MACHINE
PROCESS AT ITS OWN PACE .
8.
To resume normal film web lamination, turn speed control potentiometer to minimum speed
(Fully counter-clockwise), switch speed selector switch to variable speed position and close
roll gap control handle. Re-thread laminator as described previously.
24
