LeCroy ADP300, Инструкция по эксплуатации, Страница: 30 / 39

ADP300/305 Probe
24
ADP30X-OM-E Rev B
PERFORMANCE VERIFICATION
This procedure can be used to verify the warranted characteristics of the ADP30X series Active
Differential Probes.
If the product does not meet specifications, it should be returned to a LeCroy service center.
There are no user accessible adjustments, so there is no adjustment procedure.
Test Equipment Required
The following table lists the test equipment and accessories (or their equivalents) that are
required for performance verification of the ADP30X Active Differential probe.
This procedure is designed to minimize the number of calibrated test instruments required.
Description Minimum Requirements Test Equipment Examples
Digital Multimeter DC: 0.1% Accuracy
AC: 0.2% accuracy to measure
700 mV at 70 Hz
Agilent Technologies 34401A or
Fluke 8842A-09 or
Keithley 2001
Function Generator Sine Wave output waveforms
20 V
p-p
Agilent Technologies 33120A or
Stanford Research Model DS340
or
Leader LAG-120B
BNC Coaxial Cable
Male-to-Male 50
Ω
Cable
Pomona 5697-36
Calibration Fixture ProBus Extender Cable LeCroy PROBUS-CF01
Banana Plug Adapter Female BNC-to-Dual Banana
Plug Pomona 1269 or
Mueller BU-00260
Insulated Banana Plug
Insulated Banana Couplers (2)
Insulated BNC-to-Shrouded
Banana Plug Mueller BU-5671-B-12-0
Mueller BU-32601-2 (Red)
Mueller BU-32601-6 (Blue)
Only the parameters listed in boldface in the "Minimum requirements" column must be calibrated
to the accuracy indicated.
Because the input and output connector types may vary on different brands and models of test
instruments, additional adapters or cables may be required.
Preliminary Procedure
1. Connect the ADP30X under test to the female end of the ProBus Extension Cable.
Connect the male end of the ProBus Extension Cable to any channel of the oscilloscope.
2. Turn the oscilloscope on and allow at least 30 minutes warm-up time before performing
the Certification Procedure.