11
4 Safety instructions
4.1 General information on component operation
The safety instructions apply to all component lifecycle phases. These include transportation, instal-
lation, commissioning, service life, maintenance, troubleshooting and decommissioning.
All specialist personnel responsible for the component must read the operating and maintenance
manual. The manual must be available at all times. The personnel must read and understand the
manual.
The operating and maintenance manual must be kept in good condition. Damaged, lost or illeg-
ible pages must be replaced immediately.
All sequences and specifications relating to the correct operation of the component must be ob-
served.
Some details:
· Only use the component in accordance with specifications set out in sections 2.1 and 3!
· Do not adjust or turn any proximity switches!
Caution!
The safety mechanisms and rules must be harmonized with the safety concept
of the overall system (feed-in and removal mechanisms, drives, controller)!
The component may only be operated by authorized personnel during all lifecycle phases,
including the elimination of problems (troubleshooting).
In addition to the points mentioned throughout the manual, the following points must be ob-
served when operating the component:
· These safety instructions should be considered as a guideline and extension to applicable na-
tional legislation.
· All persons who work with the component must be familiar with the relevant component technol-
ogy.
· Repairs must be performed by qualified specialists who are familiar with the product and the
associated technology.
· Transportation and repair work, as well as installation, must be performed with extreme care
and attention to avoid any damage to the component.
· All persons who work with the component must observe the instructions and regulations set out
in the present manual.
· A completely up-to-date version of these instructions must always be present in the vicinity of the
component and be accessible to operators.
· All changes at the component that deviate from the original layout must be recorded in these
instructions.
· If any malfunction occurs then the cause must be eliminated immediately. If the cause of the
malfunction cannot be identified and/or eliminated, then help must be obtained immediately
from a specialist or from the company LEANTECHNIK AG.
4 Safety instructions
