LCN 8310-2420, Руководство по установке

Страница: 3 / 20

Installation
1
Mounting
CAUTION
The product warranty will be voided if the product is mounted for an exterior door and/or is exposed to elements.
For cleaning purposes, do not expose components to extreme wash-down.
The electric strike is not water-proof.
L
IMPORTANT: Do not apply power to the unit until you have fully read the instructions and have made the required
adjustments!
Actuators
L
NOTE: Actuators are for interior use only!
1a Prepare the cut-out for the unit and fit in the dry wall bracket.
1b Slide in the black vinyl behind the flush enclosure and fit them inside the dry wall bracket.
1c Ensure the two mounting holes on the bracket and the flush enclosure align. Use the 8-32 Phillips screws to completely
tighten in place.
1d Place the electronic board inside the flush enclosure, making sure the screw holes on the electronic board align with the
screw holes inside the flush enclosure. Use the #6 x 3/8” self-tapping screws to tighten the electronic board in place.
1e Place the diffuser insert inside the flush enclosure, making sure the mounting screw holes on the diffuser insert and the
flush enclosure align.
For Push to Open switches
a. Use the 6-32 hex head screws to tighten the diffuser
insert slightly.
b. Fit in the assembled push plate by locating the screws
with the holes on the back plate.
c. Fit the hex key through the hole on the face plate and
completely tighten the 6-32 screws in place.
For Push to Open/Push to Lock combo switch
a. Fit the plastic spacer inside the diffuser insert.
b. Place the combo switch inside the diffuser insert,
making sure the mounting holes on the board and on
the back plate align.
c. Use the 6-32 Phillips screws to tighten in place.
L
Note: Do not overtighten!
Flush electronic board
enclosure
Black vinyl
Dry wall bracket
8-32 x 1-1/2”
Phillips screw
(2 pcs)
#6 x 3/8” Phillips
self-tapping screw
(2 pcs)
6-32 Phillips
screw (2 pcs)
Diffuser
Electronic board
Plastic spacer
(For use only on Push to Open)
Label
Electronic Board Dip Switch Settings
1
REM/LOC
RELAY
SPEAKER
2
3
Enable
ON
1
RED
GREEN
BLUE
2
3
Active Color
ON
RED
GREEN
BLUE
1
2
3
Idle Color
ON
= Switch Position