Configuration with the PC
Configuring the I/O cards
zirkon Configuration Manual
V 1.2
41/ 148
The modules are assigned by an address at their rear.
Thus you can freely choose the order of the modules in
the configuration programme. However, an order
according to the real control panel makes sense as a clear
assignment of the modules facilitates the configuration.
When addressing the modules you should see that you
assign the addresses in ascending order from left to right
starting with 1, according to the graphic. The central
module carries always the address “F”.
Configuring the I/O cards
AES IN card
After a double-click on an AES IN card the displayed
window opens. The title bar names type and slot.
1.
Name the inputs. Use cleartext names (CD 1, MD 2
etc.)
This nomination makes it easier to distinguish the individual
inputs within the configuration.
In 1 / 1: AES input 1 channel 1
In 1 / 2: AES input 1 channel 2
In 2 / 1: AES – input 2 channel 1
In 2 / 2: AES – input 2 channel 2
Assigning a digital pre-amplification to a channel you
proceed as follows:
2.
Enter under Dig Offset Gain a value between -30 and
+9!
Now a digital pre-amplification is assigned to the channel.
For releasing an interface for the matrix control, proceed
as follows:
3.
Click into the box next to “Matrix enable” to set a
check mark!
When the check mark is not set the interface cannot be
connected.
If you want to connect a stereo source to this interface:
4.
Click into the box next to “Stereo” to set a check
mark!
Tip
