![background image](http://html1.mh-extra.com/html/launch/cch201/cch201_user-manual_3854031031.webp)
SPRAY BOOTH USER MANUAL
- 29 -
Chapter 4 Test and Operation
4.1 Preparation Before
4.1.1 Preparation before testing and operation
-
Prepare three phase electric power supply which is suitable for the motor connection.
-
Prepare the air compressor for the control damper.
-
Check the control system connection of the damper,the testing method as the chpter 3 mention.
-
Prepare enough diesel oil in the oil tank.
4.1.2 Attention before testing and operation
-
Check the connection of the electric chart according to the chart we offer.Make
sure that you must ask someone who has the qualification of the electrical work.
-
Check the connection of the diesel oil pile and the connector,the leakness
phnenomenon is forbidden.
-
Keep to all the signaling of danger and safety posted on the booth.
-
The qualification of the personnel, The personnel employed to work on the booth, before beginning
the work, has to have studied the "SAFETY " because during the work there will not be time. This is
important above all for the personnel who only work sporadically.
-
During the painting process,it is forbidden for the personnel to go into the booth, with non-regulation
clothing ( including necklaces, bracelets, rings etc.).
4.1.3 Test the rotation of the blower
-
Intake blower testing:Open the pre-filter cabin in the generator and check the rotation of the fan,make
sure the air can be taken in when the fan turn on.
-
Exhaust blower testing:Take out the cover panel of the exhaust cabin,check the rotation of the
fan,make sure the air can be taken out when the fan turn on.
4.1.4Test the damper system
The main function of the damper is the transition between the painting system and baking system.the test
method shown in Chaper three.
4.2 Attention Norms
In the paragraphs below are listed all the regulations and prohibitions to be observed in
order to prevent possible accidents:
-
Prepare and keep paints in a place outside of the spray painting environment.
-
Clean the inside surfaces of the oven and the glass of the overhead lights from
possible paint residue or solvents.
-
Use the spray paint gun correctly: spray only in the direction of the surfaces to be to painted
,
in order
to keep the operator in clean air.
-
Make sure that inside the vehicle there are not dangerous objects or substances.
-
Make sure that the emergency exit is free of objects that may hinder the opening in emergency cases.
-
Make sure that all the discharge air and smoke ducts are protected by the appropriate grates and that
the air passage is not obstructed.