![background image](http://html1.mh-extra.com/html/launch/cch201/cch201_user-manual_3854031018.webp)
SPRAY BOOTH USER MANUAL
- 16 -
2. Adjust the level of the connect point: find the highest point with the level measure apparatus,then
elevate other points with something.Shown in Fig.3.5
3. Adjust the uprightness: adust the side boards and middle bracket with beeline,and distribute the distant
between the rows,so that we can put the grids easily.Shown in Fig.3.5.
4. Check that all the longitudinal pieces have been mounted perfectly perpendicular to the end heads, to
do this measure the two diagonals between the corner of the anterior end head and the opposite corner of
the anterior end head, if they show the same values we are certain that it is assembled correctly. and the
error value should be less than 5mm (shown in Fig.3.5).
5. Installate the bottom of the heat-air generator: the air out mouth should be connect with the metal sides
board.(shown in Fig.3.5)
Fig. 3.5
3.3.2 Main room installation
1. Front door installation
Installate the front door frame(shown in Fig.3.6)
1)
Put the left and right side panel (B01&B03)on the ground,connect the the horizontal panel(B02) with
the side panel.make sure that the gap should be smallest.
2) Measure the diagonal of the length and width,when they are suitable for the demand of the door
frame size (shown in Fig.3.6),L1=L2,fix the door frame with appoint connect board(B04).Pay attention to
that check the sizes of the door frame after fixing.