SPRAY BOOTH USER MANUAL
- 37 -
Appendix I : Malfunction and Remedy
MALFUNCTIONING PROBABLE
CAUSE
REMEDY
The moter can not
Start
1.
Fusing fault
2.
Thermal relay in operation
3.
The motor,wires circuit break
1.
Change new fuse
2.
Push button of thermal relay
reposition
3.
Change the moter and wires
The Capacity of the fan
is small
1.Pre-filter Jam
2.Damper have been right open or
not open enough position
1.Clean or change the filter
2.Open the damper completely
Burner malfunction
light turn on after the
burner have started 20
seconds
1.
Use out of oil in the reservior
2.
Oil pipe connector leakage
3.
Too dirty in the filter net of the
oil intake pipe
4.
Electrical ege is too dirty
1.
Add some diesel
2.
Reconnect the pipe
3.
Clean the fliter net
4.
Clean the eletrical ege
The pump of burner
does not start to work
1.
The pump strip is lock
2.
The setted time have finish
3.
The temperature valve have
reach the setted valve
4.
The burner is out of fuel
1.
Check and clean the pump of the
burner
2.
Reset the time
3.
Reset the temperature
4.
Check the level of fuel in the
reservior
Black smoke come out
after the burner open
1.
The open position of burner
damper is not enough
2.
The pressure of pump is not
enough
1.
Adjust the damper more to more big
position
2.
Reset to the standard valve
Temperature rise is
slow
1.The damper is not close or not
closed completely
1.Closed the damper completely
The lights do not work
1.
The fuses have blown
2.
Ballast is interrupted
3.
Connection ports loose
1.
Replace the light fuses
2.
Replace the ballast
3.
Fix the connection ports
The pressure inside the
booth is higher than
usual
1.
The motor of the exhaust ir
unit is off or not working
regularly.
2.
The extraction duct is
obstructe
d
1.
CheckThe exhaust air unit fuses
Ensure the cable is connectyed to
the motor and the the locks of the
control panel
2.
Check the filter of the basement or
the exhaust air unit and replace
them if necessary.
The pressure in the
booth is lower than
usual
1.The motor of the generator is off
or does not work regularly
2.The emission duct is obstructed
1.Check the generator fuses. Ensure the
cable is connected the motor and the
locks of the control panel.
2.Check there are not obstacles at the
mouth of emission of the intake air unit.
