1
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
PACKAGE CONTENTS
PLANNING FOR A SUCCESSFUL ASSEMBLY
Read all instructions before assembly and installation.
Inspect each part for defects that may have occurred during shipping.
Keep your receipt and these instructions for proof of purchase.
CHOOSING THE RIGHT LOCATION
Install your solar light in a location with full, direct sunlight. Do not install the solar
panel in shaded areas as these areas will not allow the battery to fully charge and
reduce the nighttime operating hours for your light. Ensure that the installation
location is away from other nighttime light sources such as street or porch lamps.
These light sources may prevent your solar light from automatically turning on.
Part
Description
Quantity
A
Flag light head and solar panel
1
B
Fixing bracket with compression nut (pre-installed)
2
C
Bracket
2
D1
Bolt (M5x55 mm)
4
D2
Bolt (M5x30 mm)
4
E
Wing nut
4
F
1100mAh LiFePO4, 18500, 3.2V rechargeable
battery (pre-installed)
1
G
Wall anchor
4
H
Screw
4
I
Rubber cap for bolt
4
HOW SOLAR WORKS
The solar light has a solar panel that converts sunlight into electricity. During the day, the converted electricity is stored in the rechargeable battery. At night, the
solar light is powered by the battery using the electricity stored during the day. The operating time depends on geographical location, daily weather conditions, and
season. For optimal performance during the evening, allow the battery to charge for 6 to 7 hours in direct sunlight.
Assembly and Installation
Preparing for installation
Installing the flag light
on a wall (Option 1)
□
FOR FIRST TIME USE: Slide the switch to the ON
position.
□
Hold the fixing bracket (B) to the wall and mark the
holes with a pen or marker. Drill two holes (1/4 inch
in diameter, 1 inch in depth) and insert wall anchors
(G) into the holes.
□
Align the fixing bracket (B) with wall anchors (G), and
use the screws (H) to mount the solar panel (A).
□
Repeat the previous steps to mount the flag light (A).
1
2a
Installing the flag light
on a post (Inline option)
□
Place the fixing bracket (B) of the flag light
and the fixing bracket (B) of the solar panel
against the post.
□
Install the bolts (D1 or D2) through the fixing
brackets (B) and fasten the wing nuts (E)
onto the bolts (D1 or D2), twisting them
clockwise until tight.
□
Add the rubber cap (I) to the end of the bolt
to prevent the flag from tearing on it.
2b
NOTE: For wood installation, use screws (H)
only. The wall anchors (G) are not necessary.
NOTE: Different mounting options allow for
various lighting angles. Choose the best
option for your application.
D1 or D2
E B
B
I
D1 or D2
Use and Care Guide
Solar Flag Light
Item #xxxx xxx xxx
Model #91932
NOTE: There are two kinds of bolts
(D1, D2). Choose the correct one
according to the flag post diameter.
B
C
D1
E
F
A
G
H
D2
I
G
B
B
H
H
G
A
A
